We've Moved! Please visit our new and improved forum over at our new portal: https://portal.plumvoice.com/hc/en-us/community/topics
Verifying a response
-
- Posts: 69
- Joined: Wed Feb 24, 2010 5:59 pm
- Location: Chagrin Falls, OH
- Contact:
Verifying a response
When a response is recorded, how can we repeat the response to the caller to affirm its accuracy? Is there a preferred method, other than using either a single or multipart yes/no prompt?
DMIVS
Verifying an IVR response
Hi Wayne,
The method you proposed, using a Multipart + Yes/No prompt, is the preferred module to use when verifying a response.
In your Multipart + Yes/No module, you could have the following:
"You said <module variable>. Is this correct? Press 1 for Yes or 2 for No."
From there, if the caller enters 2 for No, you can branch back to the previous module to reprompt. If the caller enters 1 for Yes, you can branch off to continue your application.
Hope this helps.
Regards,
Plum Support
The method you proposed, using a Multipart + Yes/No prompt, is the preferred module to use when verifying a response.
In your Multipart + Yes/No module, you could have the following:
"You said <module variable>. Is this correct? Press 1 for Yes or 2 for No."
From there, if the caller enters 2 for No, you can branch back to the previous module to reprompt. If the caller enters 1 for Yes, you can branch off to continue your application.
Hope this helps.
Regards,
Plum Support
Plum Support
http://www.plumvoice.com
http://www.plumvoice.com